Designed for the quality-conscious shop with a lower service volume, the DSP7705 is a rugged economy balancer with features that ease service and provide fast, accurate results.

The DSP7705 handles a wide range of wheel designs up to 44 inches in diameter and 20 inches in width. The powerful motor can spin assembles up to 150 lbs. repeatedly without overheating.

The DSP7705 is simple to operate, even for first-time users. The intuitive display uses easy-to-understand wheel graphics and simple controls to help operators enter wheel dimensions, determine the best weight placement, and navigate through balancing procedures.

The Dataset® arm assists with automatic direct measurement of wheel dimensions when using tape weights, eliminating manual data entry errors.

The DSP7705 also supports a series of patented features to speed service and increase profitability.

Servo Stop control automatically positions wheels at the top-dead-center weight location, saving time and ensuring accuracy.

Split Spoke® mode automatically locates the best out-of-sight position for adhesive weight placement on custom wheels, and Split Weight® mode splits the weight reading into two weights and relocates them on the wheel to help reduce weight inventories and avoid trim ring obstructions.

CenterCheck® verification indicates proper centering of the wheel before proceeding with the balance, and Quick Cal-Check® confirms if calibration is needed at any time.

For more information on the DSP7705 wheel balancer, click here.

Hunter Engineering is the leader in alignment systems, wheel and tire service, brake service and inspection lane equipment. Hunter equipment is approved and used by vehicle manufacturers, automobile and truck dealers, tire dealers and service facilities around the world.

For additional information, visit our website at www.hunter.com or contact Robert Bruce, Advertising Manager, Hunter Engineering Company, 314-716-0443.

11250 Hunter Drive • Bridgeton, Missouri 63044 USA • (314) 731-3020