Press Release

Hunter's RMHD Parallelogram Lift Rack Combines Heavy-Duty Lifting Capabilities With a Space-Saving Design

The RMHD's parallelogram design requires minimum bay width and provides post-free access to the vehicle. The RMHD features a massive 16,000-lb. lifting capacity and lifts to a 65” working height. The extra-wide 22.5” runways with louvered ramps allow for easy positioning of the vehicle. Flush-mounted, full-floating slip plates are 80” in length and allow the vehicle's rear suspension to “relax” for maximum alignment accuracy. The RMHD runways are constructed of heavy-duty 5/16” steel, compared to commonly used 1/4” or 11/64” lighter weight metals.

The RMHD offers a maximum general service wheelbase of 190.5”, a maximum two-wheel alignment wheelbase of 177.5” and a maximum four-wheel alignment wheelbase of 158”.

The patented, low-voltage feedback hydraulic system ensures the lift rack is alignment level at each of the 20 lock positions and safely stops the rack if obstructed. In the event of pressure loss, hydraulic velocity safety fuses shut down operation immediately.

Two movable, lightweight aluminum work steps come standard to give the technician easier access to the vehicle when up on the rack. A built-in air line kit also comes standard, providing connections at the front and rear of the lift rack for air tools and powering jacks.

Optional 8,000-lb. capacity swing air jacks add the capability of lifting vehicles off the runways during alignment procedures and other service operations.

Hunter Engineering is a world leader in wheel alignment, brake service, wheel service and safety inspection lane equipment. Hunter equipment is approved and used by vehicle manufacturers, automobile and truck dealers, tire dealers and automotive service facilities around the world.

For additional information contact Robert Bruce, Advertising Manager, Hunter Engineering Company, 314.731.3020 (x443).

11250 Hunter Drive • Bridgeton, Missouri 63044 USA • (314) 731-3020