4-Post MKS Alignment Rack
Hunter’s MKS Alignment Rack combines a 158” four wheel
alignment wheelbase, 22 1/2” runway width and 12,000 pound capacity
to provide full service capability for a wide range of Mercedes-Benz vehicles. |
|
- Multi-service use, no floor obstructions
Floor area is clear for technician, tools and equipment.
- Locks at any of 20 heights
Locks at a maximum 70” runway height. Alignment level is
set at 1 mm for any of the 20 lock positions; leveling legs are not needed.
- Fully equipped for four-wheel alignment
Full floating rear-wheel slip plates allow the vehicle’s
rear suspension to be “relaxed” for maximum alignment
accuracy. Includes built-in turnplate pockets and spacer kit with
tethered lock pins.
|
MKS Alignment Rack (4P DC) shown with an optional
second 8,000 lb. capacity Swing Air-Jack. |
|
- Includes Mercedes-Benz compliant MKS Alignment Sensor Brackets (set of four).
- Extra-wide 22 1/2” runways handle a wide variety of passenger cars, light and medium trucks.
- Runways are heavy-duty 5/16” steel, compared to commonly used 1/4” or 11/64” lighter weight materials.
- Full floating, 80” long rear wheel slip plates included.
- Standard 8,000 lb. capacity Swing Air-Jack adds capability of lifting vehicles off the runways during alignment procedures. Includes one Center-Lift Jack Adaptor.
- Built-in rub rails add drive-on safety.
- Front and rear wheel stops and two wheel chocks (not pictured) are standard.
- Two-stage, heavy duty gusseted rear ramps automatically flip up to act as wheel stops. Wheel rollers won't damage floor. Low approach angle for low-ground clearance vehicles.
- Louvered ramps prevent wheel spin, are more effective than diamond tread or abrasive strips in wet weather.
- Integral Harting Rack Wiring Kit and air kit included.
|
|
DSP306L-E Sensors mounted on MKS Alignment Sensor Brackets.
Standard 8,000 lb. capacity Swing Air-Jack. |
Ordering Information
