HTA-MB Specifications:
Hardware (Series S811) Effective 03/03
- 1.7 GHz processor (minimum)
- 128 MB RAM
- DVD-ROM Drive
- 40.0 GB Hard Drive (minimum)
Software:
- Mercedes-Benz approved software and specification database (2 years free specification database updates)
- WinAlign® software and Windows® XP
Standard Equipment:
- 17” UVGA color monitor
- DSP306L-E sensors
- Color Printer
- Electronic Authorization Key for MB software
- Interface Kit for MB Electronic Level Gauge
- Electronic turnplate kit (20-1573-1)
- Harting 5 Cable Kit for connecting to a MB MKS equipped rack (20-1374-1)
- 50mm Offset adaptor (set of 2) (20-1394-1)
- Sensor Calibration Kit (required for the calibration of DSP306L/308L sensors used with HTA-MB alignment systems)* (221-652-1)
Options:
- Mercedes-Benz approved Quick Clamp Adaptor 175-215-1 (four required)
Console Options:
- S811-17-MB S-Style 811 with 17” UVGA color monitor
- S811-19-MB S-Style 811 with 19” UVGA color monitor
- R811-17-MB R-Style 811 with 17” UVGA color monitor
- R811-19-MB R-Style 811 with 19” UVGA color monitor
Sensor Options:
- DSP308L-E DSP308L sensors with rear toe arms
- DSP306L-HFSS Cordless DSP306L sensors
- DSP308L-HFSS Cordless DSP308L sensors with rear toe arms
*The calibration fixture is required unless the retailer agrees to have Preventative Maintenance
visits performed by Hunter Service Representatives. |
|
MKS Rack Specifications:
- Maximum Vehicle Gross Weight: 12,000 lbs.
- Maximum Wheelbase
– General Service 188 1/2”
– 4-Wheel Alignment 158”
- Minimum 4-Wheel Alignment
Wheelbase: 88”
- Tread Width
– Minimum Inside Tires 40”
– Maximum Outside Tires 85”
- Alignment Height: Any of 20 Lock Positions,
in 2 3/4” Increments
- Maximum Height: 70”
- Electrical Requirements: 208/230 Vac, 1 Ph. 50 Hz/60 Hz
- Shipping Weight: 6,000 lbs.
- Air Requirements: 80 lbs. psi (Minimum)
- Raise Time: 44 seconds
Standard Equipment:
- Built-in air line kit
- MKS Brackets
- Harting Rack Wiring Kit
- Two 2-stage approach ramps
- Two rear ramp stops, two front wheel stops
- Two wheel chocks
- Moveable clip-on Work Step with skid protection
- Built-in rub rails
- Built-in full-length jack rails
- Built-in electronic turnplate pockets
- Lubricator/Air Filter with Auto Drain
Model:
4P DC 4-Post, 12,000 lb. capacity, 3 HP with
8,000 lb. capacity Swing Air-Jack
Options:
- 133-62-1 8,000 lb. capacity Swing Air-Jack
- 51-1696-1 Work step
- 133-63-1 4,500 lb. capacity Power Jack
- 133-35-1 4,500 lb. capacity Swing Air-Jack
|
Ordering Information
