|
|
RX DC MKS Compliant Alignment Lift
Approved For Mercedes-Benz USA Dealers
Engineered to Meet the Specific Requirements for Aligning Mercedes-Benz Vehicles
|
Large Capacity Lift With a Small Footprint
Hunter’s RX DC Alignment Lift combines a 158” (4013 mm) four- wheel alignment wheelbase, 24” (610 mm) runway width and 11,000-lb. (5000 kg) capacity to provide full-service capability for a wide range of Mercedes-Benz vehicles.
- Multi-service use, clear service access all the way to the rear of the vehicle
- Locks at any of 18 heights, with a maximum 68” (1727 mm) runway height
- Fully equipped for four-wheel alignment
See Flash Animation
|
|
Extra-wide 24” runways handle a wide variety of vehicles, including the new Maybach. |
|
RX DC shown with optional second swing air jack. |
|
- Integral Harting rack wiring kit.
- PowerSlide locking mechanism secures full-floating, 80” (2032 mm) long rear wheel slip plates once alignment measurements have been collected. Saves time by no longer requiring trips around lift to secure the rear slip plate pins.
- Includes Mercedes-Benz compliant MKS alignment sensor brackets (set of four).
- Two-stage, heavy-duty gusseted rear ramps automatically flip up to act as wheel stops. Low approach angle for low-ground clearance vehicles (e.g., SLR model). Wheel rollers won’t damage floor.
- Louvered ramps help prevent wheel spin and are more effective in wet weather than diamond tread or abrasive strip designs.
- One standard 6,000-lb. (2724 kg) capacity swing air jack adds capability of lifting vehicles off runways during alignment procedures. Includes one center-lift jack adaptor and built-in air kit.
- Built-in rub rails add drive-on confidence.
- Extra-wide 24” (610 mm) runways provide easy vehicle positioning.
|
|
MKS RX DC Lift Specifications:
- Maximum Vehicle Gross Weight: 11,000 lbs. (5000 kg)
- Maximum Wheelbase:
General Service: 175” (4445 mm)
2-Wheel Alignment: 161” (4089 mm)
- 4-Wheel Alignment Range:
Maximum: 158” (4013 mm)
Minimum: 88” (2235 mm)
- Tread Width:
Minimum Inside Tires: 40” (1016 mm)
Maximum Outside Tires: 88” (2235 mm)
- Alignment Height: Any 18 lock positions
- Maximum Height: 68” (1727 mm)
- Electrical Requirements: 208-230 volt, 1-ph, 60 Hz, 22A
- Air Requirements: 90-120 psi
- (1) 6,000-lb. capacity adaptor swing air jack, #133-69-1
- Center-lift jack #20-1591-1
- (2) Moveable worksteps*
- (2) Wheel chocks
- Front wheel stops
- Air line kit
- *Except (-P) Flush Mount Models
- (1) 6,000-lb. Capacity Swing Air Jack is standard. Other jacks may be substituted and/or a second jack of any type may be added.
- 133-69-1 6,000-lb. Capacity Swing Air Jack
133-67-1 4,500-lb. Capacity Swing Air Jack
133-63-1 4,500-lb. Capacity Air-Actuated Power Jack
|
|
Ordering Information
|
|
|
